home
Leave catalogue

Demagnetisers

These Demagnetisers are the models most used in any workshop where it is necessary to get rid of residual magnetism from machining parts in magnetic or electromagnetic plates.

Instructions for correct use of Demagnetisers:

Place the part that is to be demagnetised on the demagnetiser, connect it and drag it over its surface until it is 30 cm from the demagnetiser. Then without bringing the part close to the demagnetiser, disconnect it. If the part is not totally demagnetised, repeat the same steps.

These devices are of intermittent service, of maximum 10 minutes.


Tunnel Demagnetiser

These demagnetisers are of continuous service and may be connected during all the necessary time. The part that has to be demagnetised goes through the interior of the device and is specially appropriate for automatic processes in which there is a material flow.

Standard Measurements Listings

Code A B C D E Intensity Power weight Kg
70.30.012 150 60 200 250 160 3.8A 870 27
70.30.017 200 100 200 330 230 10.1A 2.320 45

Portable Demagnetiser

This model is used for demagnetising big-size pieces, which cannot be manipulated easily.

Instructions for use: hold the device by the handle and pull it over the surface of the piece that has to be demagnetised.

Code A B C Intensity Power weight Kg
70.01.001 120 105 180 5.8A 1.330 5.5

Table Demagnetiser

These demagnetisers are of intermittent use. They may not be connected for more than 10 minutes. They have an incorporated thermostat which disconnects them when they reach the maximum admissible temperature.

Code A B C Intensity Power weight Kg
70.01.001 160 120 115 1.3A 286VA 5.5
70.01.002 220 170 122 3A 660VA 12

Please Select One Of Our Products: